2135B72 ELECTRONIC AUTOMATIC TRANSMISSION INPUT RPM SENSOR - R R (AUTOMATIC TRANSMISSION) - Alfa - 166 - eLearn

3314524 - 2135B72 electronic automatic transmission input rpm sensor - r r (Automatic transmission)

) Place the vehicle on a ramp. Make sure that the ignition is in the OFF position, then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1

- 7055B54 under-engine guard - r r . - 1048A28 vacuum air circuit resonator pipe - r+r . - 2130B38 automatic transmission top cover - r + r on vehicle . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . 1. Undo the bolt and remove the electronic automatic transmission input rpm sensor from its seating.2. Disconnect the wiring connection (2a) and remove the electronic automatic transmission input rpm sensor (2b).

	Name	Connector
2a	Data not available yet	-

Refitting ( Removing

) Connect the electrical connection to the electronic automatic transmission input rpm sensor.Refit the electronic automatic transmission input rpm sensor in its seating and tighten its bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ELECT. AUTOMATIC. TRANSMISSION INPUT RPM SENSOR.	-	-

- 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 2130B38 automatic transmission top cover - r + r on vehicle . - 1048A28 vacuum air circuit resonator pipe - r+r . - 7055B54 under-engine guard - r r . Connect the negative (-) battery terminal.Remove the vehicle from the ramp.