4130B49 RETURN PIPE FROM POWER STEERING CASE TO HEAT EXCHANGER PIPE R R - Alfa - 166 - eLearn

3314644 - 4130B49 return pipe from power steering case to heat exchanger pipe r r

) Position the vehicle on the ramp.Draw off the fluid from the power assisted steering reservoir using a suitable syringe. - 7055B54 under-engine guard - r r . - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (Right and left). 1. Undo the bolts (1a) and remove the power steering box heat shield (1b).

1. Undo the connector (1a) and disconnect the return pipe from power steering box to heat exchanger (1b), power steering box side.

1. Undo the nuts (1a) and release the return pipes from power steering box to heat exchanger (1b) from the mounting brackets (1c).

1. Undo the bolts securing the radiator support beam to the bumper.

1. Use a suitable shim to move away the lower edge of the bumpers.2. Undo the connector (2a) and disconnect the return pipe from power steering box to heat exchanger (2b), heat exchanger side.

1. Release from its attachment (1a) on the front suspension subframe and remove the return pipe from power steering box to heat exchanger (1b).

Refitting ( Removing

) Refit in its seating the return pipe from power steering box to heat exchanger and secure it to the front suspension subframe.1. Connect the return pipe from power steering box to heat exchanger (1a), heat exchanger side, and tighten the connector (1b) to the recommended torque.2. Remove the shim used to move away the lower edge of the bumpers.

Tighten the bolts retaining the bumpers to the radiator support beam.Fix the return pipe from power steering pump to heat exchanger with the relevant mounting brackets and tighten the nuts.1. Connect the return pipe from power steering box to heat exchanger (1a), power steering box side, and tighten the connector (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Connector	PIPE FROM POWER STEERING BOX/EXCHANGER	M12	(Power steering box side) 3.2 - 3.6

Refit in its seating the power steering box heat shield and tighten its bolts. - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (Right and left). - 7055B54 under-engine guard - r r . Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	-

Bleed the power steering system as described below.With the front wheels raised off the ground, with the engine switched off, carry out 4-5 complete steering wheel rotation cycles (left and right).Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramp.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.