4130B95 RIGID PIPES DUPLEX OF POWER STEERING SYSTEM HYDRAULIC CIRCUIT FROM TO HEAT EXCHANGER COIL OR RADIATOR R R FOR RIGHT HAND DRIVE VERSIONS - Alfa - 166 - eLearn

3314655 - 4130B95 rigid pipes duplex of power steering system hydraulic circuit from to heat exchanger coil or radiator r r for right hand drive versions

) Position the vehicle on the ramp. - 4450B12 front or rear wheels (two) - r+r - 7055B41 front supplementary wheel arch half (one), lh or rh, rear element r r - 7055B54 under-engine guard - r r Guard beneath engine]. - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r - 4130B73 return pipe from power steering case to rigid intermediate pipe r r for right hand drive versions1. Disconnect the rigid pipe from the exchanger to the power steering reservoir, rigid pipe side.

1. Disconnect the power steering box / exchanger rigid pipe (1a) and the exchanger / power steering rigid pipe (1b), rigid pipes side.

1. Unscrew the two bolts retaining the power steering system hydraulic circuit rigid duplex pipes.

1. Undo the bolts fixing the power assisted steering box to the front suspension frame.

1. Release and remove the power steering system hydraulic circuit rigid duplex pipes from the power steering box, withdrawing them from the left wheel compartment.

Refitting ( Removing

) Place the power steering system hydraulic circuit rigid duplex pipes back in their housing.1. Tighten the bolts fixing the power assisted steering box to the front suspension frame to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1	Nut	POWER STEERING BOX	M12	Front suspension frame side 10.5 - 11.5

Tighten the two nuts securing the power steering system hydraulic circuit rigid duplex pipes.Connect the power steering box / exchanger rigid pipe and the exchanger / power steering rigid pipe, rigid pipes side. - 4130B73 return pipe from power steering case to rigid intermediate pipe r r for right hand drive versions - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r - 7055B54 under-engine guard - r r Guard beneath engine]. - 7055B41 front supplementary wheel arch half (one), lh or rh, rear element r r - 4450B12 front or rear wheels (two) - r+rFill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	-

Bleed the air from the power steering system as described below.With the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the vehicle from the ramp.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.