3314769 - 5040A20 air conditioner compressor - r+r - includes fluid level check and top up if necessary

Follow the safety instructions (  See assembly 5040A   air conditioner coolant circuit ).

Follow the safety instructions (  See assembly 5040A   air conditioner coolant circuit ).

Follow the safety instructions (  See assembly 5040A   air conditioner coolant circuit ).

Follow the safety instructions (  See assembly 5040A   air conditioner coolant circuit ).

Removing ( Refitting ) Position the vehicle on the ramp Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

	Name	Connector
-	Battery	A1B

 - 4450B10  Front WHEEL (one) - R.R. (right).  - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. (right).  - 1092G10  single engine belt r r .  - 5040A10  Air conditioning refrigerant CIRCUIT - Draining and Refilling .  - 5040A44  air conditioner dehydrating filter/accumulator - r+r . 1. Undo the two nuts for the bolts fixing the air conditioning compressor. 1. Disconnect the electrical connection for the air conditioning compressor electro-magnet coupling.

	Name	Connector
1	Air conditioning compressor engagement electro-magnet	L20

2. Undo the bolt (2a) and disconnect the coolant fluid inlet and outlet pipes (2b) from the compressor.

Seal the disconnected connectors, using suitable plugs, to prevent humidity and impurities from entering the system.

1. Remove the bolts (1a) and remove the air conditioning compressor (1b). Refitting ( Removing ) If replacing the compressor, proceed as follows.1. Remove the drain plug and drain the fluid from the compressor.

Manually rotate the compressor to facilitate the removal of all the fluid.

the fluid is extremely hygroscopic: avoid leaving the containers open. Avoid leaving the compressor or any other component disconnected from the system for longer than is strictly necessary.

1. Recover the fluid drained from the compressor in a suitable transparent container (quantity A).2. Drain and recover the fluid from the new compressor (quantity B) in an identical container, following the instructions given previously.3. Introduce the same amount of fluid removed from the compressor being replaced into the new compressor (eliminate quantity C = B - A). Fit the air conditioning compressor and support it using the bolts.1. Connect the coolant fluid inlet and outlet pipes (1a) to the compressor and fix them tightening the bolt (1a) to the recommended torque.

Replace the O-Ring seals for the connectors. Only use green coloured seals, resistant to R134A coolant fluid. Lubricate the thread of the connectors using anti-freeze.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	Air conditioning compressor inlet/outlet pipes.	M10	Air conditioning compressor side 4.1 - 5.0

2. Connect the electrical connection for the air conditioning compressor electro-magnet coupling. 1. Tighten the nuts for the bolts fixing the air conditioning compressor to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	AIR CONDITIONER ASSEMBLY COMPRESSOR	M10	Support side 3.4 - 4.2

 - 5040A44  air conditioner dehydrating filter/accumulator - r+r .  - 5040A10  Air conditioning refrigerant CIRCUIT - Draining and Refilling .  - 1092G10  single engine belt r r .  - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. (right).  - 4450B10  Front WHEEL (one) - R.R. (right). Connect the negative (-) battery terminalRemove the car from the ramps.