1008A42 GEAR BOX LEFT RIGID MOUNT - R R - Alfa - 166 - eLearn

3314034 - 1008A42 gear box left rigid mount - r r

) Place the vehicle on a ramp. Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 4450B10 Front WHEEL (one) - R.R. (left).. - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 7055B54 under-engine guard - r r . 1. Undo the bolt (1a) and disconnect the earth lead (1b) from the gearbox side rigid power unit support.

	Name	Connector
1b	Battery earth	C1

Position a hydraulic jack under the gearbox.2. Undo the bolts fixing the gearbox side support flexible mounting to the suspension supporting frame.

Raise the power unit, as necessary, using the hydraulic jack.1. Undo the bolts (1a) and remove the gearbox side rigid power unit support (1b) complete with flexible mounting (1c).

1. At the bench, undo the nut (1a) and separate the gearbox side rigid power unit support (1b) from the flexible mounting (1c).

Refitting ( Removing

) 1. Fix the flexible mounting (1a) to the gearbox side rigid power unit support (1b) tightening the nut (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Nut	POWER UNIT GEAR BOX END RIGID MOUNT	M10	(Flexible mounting side) 3.8 - 4.7

1. Fit the gearbox side rigid power unit support (1a), complete with flexible mounting (1b), and fix it to the gearbox tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	POWER UNIT GEAR BOX END RIGID MOUNT	M10	(Gearbox side) 4.3 - 5.3

Lower the power unit, as necessary, using the hydraulic jack.

1. Tighten the bolts fixing the gearbox side support flexible mounting to the suspension supporting frame to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	GEARBOX SIDE RUBBER MOUNT	M8	(Suspension support frame side) 2.4 - 2.9

Remove the hydraulic jack previously positioned under the gearbox.2. Connect the earth lead (2a) to the gearbox side rigid power unit support and fix it using the bolt (2b).

- 7055B54 under-engine guard - r r . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 4450B10 Front WHEEL (one) - R.R. . Connect the battery terminal (-).Remove the car from the ramp.