3314252 - 1056B17 throttle body intergral with dvl - r r (Automatic transmission)

Removing ( Refitting ) Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

	Name	Connector
-	Battery	A1B

 - 7040D12  engine front side cover (one) lh or rh - r r (left)..  - 7040D14  engine bay rear side cover (one) lh or rh - r r (left)..  - 1048A48  throttle heater sleeve - r r . 1. Disconnect the electrical connection from the throttle casing integrated with the D.V.L.

	Name	Connector
1	Integrated throttle body actuator	N75

2. Undo the bolts (2a) and remove the throttle body integrated with the D.V.L. (2b) complete with gasket. Refitting ( Removing )

When refitting, it is essential to repeat the learning procedure for the throttle body integrated with D.V.L. (Carry out Op.   1056B81  run electronic ignition/injection control unit (single) self-learning procedure .

Fit the throttle body integrated with the D.V.L. complete with gasket and fix it with the relevant bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BUTTERFLY VALVE CASE/S (MPI)	M6	Air chamber side 0.8 - 1.1

Connect the electrical connection to the throttle body integrated with the D.V.L. - 1048A48  throttle heater sleeve - r r .  - 7040D14  engine bay rear side cover (one) lh or rh - r r (left)..  - 7040D12  engine front side cover (one) lh or rh - r r (left).. Connect the battery terminal (-).