3314268 - 1068A50 accelerator potentiometer - r+r (Automatic transmission)

Removing ( Refitting )  - 7040A43  cover (one only) for wiring beneath facia - r r .  - 7040A37  fuse box cover - r r .  - 7040A65  passenger compartment box lock , one , r r .  - 5580C18  air bag module - r+r .

Closely follow the safety regulations established for this operation.

 - 7040A26  steering column trim - r+r .  - 4110A11  steering wheel - r+r for replacement or check for versions with air bag .  - 5550A12  complete stalk unit - r+r for versions with air bag .  - 5505A18  multi-function control unit - r r .  - 7040D12  engine front side cover (one) lh or rh - r r (left)  - 7040D14  engine bay rear side cover (one) lh or rh - r r (left)  - 3330B02  pedal assembly - r r . 1. At the bench, disconnect the accelerator pedal potentiometer from the linkage.2. Undo the bolts (2a) and remove the accelerator pedal potentiometer (2b). Refitting ( Removing ) Fit the accelerator pedal potentiometer and secure with its bolts.Connect the accelerator pedal potentiometer to the linkage. - 3330B02  pedal assembly - r r .  - 7040D14  engine bay rear side cover (one) lh or rh - r r (left)  - 7040D12  engine front side cover (one) lh or rh - r r (left)  - 5505A18  multi-function control unit - r r .  - 5550A12  complete stalk unit - r+r for versions with air bag .  - 4110A11  steering wheel - r+r for replacement or check for versions with air bag .  - 7040A26  steering column trim - r+r .  - 5580C18  air bag module - r+r .  - 7040A65  passenger compartment box lock , one , r r .  - 7040A37  fuse box cover - r r .  - 7040A43  cover (one only) for wiring beneath facia - r r . After refitting the accelerator pedal potentiometer, adjust it as described below.Make sure that the ignition key is in the OFF position.Connect the tool to the diagnostic socket and place the knob in position 3.

	Name	Country
-	MPX 97 switch	1.806.365.000

Connect the Examiner diagnostic equipment.Turn the ignition to the ON position).Using the Examiner, enter the "Parameters" field.Press "Selection" and select the "Accelerator position track 1" parameter.

Check that the potentiometer's calibration conforms to the specified values:

• during idling (accelerator pedal released), 8% ± 1%
• fully open (accelerator pedal fully depressed), 64.3% ± 1%.

If the setting is not as specified, adjust the accelerator pedal travel by means of the accelerator pedal travel stop.Remove the diagnostic equipment.