3314656 - 4130B96 return pipe between rigid pipes duplex from heat exchanger to intermediate pipe for power steering fluid resevior

Removing ( Refitting ) Position the vehicle on the ramp.Draw off the fluid from the power assisted steering reservoir using a suitable syringe. Proceed with the removal  - 4450B10  Front WHEEL (one) - R.R. (Left side). Proceed with the removal  - 7055B41  front supplementary wheel arch half (one), lh or rh, rear element r r (Left side). Proceed with the removal  - 7055B54  under-engine guard - r r . 1. Disconnect and remove the return pipe between the rigid pipe from the heat exchanger to the power steering reservoir rigid intermediate pipe. Refitting ( Removing ) Place in its seating and connect the rubber return pipe between the rigid pipe from the heat exchanger to the power steering reservoir rigid intermediate pipe. Proceed with the refitting  - 7055B54  under-engine guard - r r . Proceed with the refitting  - 7055B41  front supplementary wheel arch half (one), lh or rh, rear element r r (Left side). Proceed with the refitting  - 4450B10  Front WHEEL (one) - R.R. (Left side). Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	1.4

Bleed the power steerign system as described below.With the front wheels raised off the ground, with the engine switched off, carry out 4-5 complete steering wheel rotation cycles (left and right).Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramp.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.