3314676 - 4410C10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Position the vehicle on the ramp. - 4450B12  front or rear wheels (two) - r+r .  - 7055B41  front supplementary wheel arch half (one), lh or rh, rear element r r (left and right).  - 4410A80  damper lower fork - r r (left). 1. Undo the nuts (1a) and disconnect the anti-roll bar joints (1b) from the anti-roll bar.

Recover the right anti-roll bar joint.

2. Undo the bolts fixing the anti-roll bar brackets to the front suspension fram.  - 7055B54  under-engine guard - r r .  - 1076B52  exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (right) Refitting ( Removing ) Replace the front suspension anti-roll bar in its housing.Remove the shim placed between the front suspension frame and the bodyshell.Tighten the front bolts on the left hand side fixing the front suspension frame to the bodyshell to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Front bolts	FRONT SUSPENSION SUBFRAME	M12	(Bodyshell side) 10.5 -11.6

1. Fit the spacers (1a), the bracket (1b) and tighten the rear bolts on the left hand side (1c) fixing the front suspension frame to the bodyshell.

	Fastening	Component	Ø	Value(daNm)
1c	Rear bolts	FRONT SUSPENSION SUBFRAME	M12	(Bodyshell side) 12.4 - 13.7

2. Fit the bracket (2a) fixing the brake pipes to the bodyshell and fix it using the nut (2b). 1. Tighten to the specified torque the bolts securing the power steering box to the front suspension subframe.

	Fastening	Component	Ø	Value(daNm)
1	Nut	POWER STEERING BOX	M12	Front suspension frame side 10.5 - 11.5

 - 1076B52  exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (right)