5510C34 RPM AND TIMING SENSOR (SINGLE) - R+R - Alfa - 166 - eLearn

3314839 - 5510C34 rpm and timing sensor (single) - r+r

) Position the vehicle on the lift. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 7055B54 under-engine guard - r r . - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (left). 1. Undo the bolts (1a) and remove the engine flywheel lower protection (1b).

1. Undo the bolts (1a) and remove the engine rpm and timing sensor (1b) from its housing.Release the engine rpm and timing sensor electrical wiring from the fixings.

1. Disconnect the electrical connection for the rpm and timing sensor then remove it.

	Name	Connector
1	Rpm sensor	K46

Refitting ( Removing

) Place the engine rpm and timing sensor back in its housing and connect the electrical connection.Tighten the bolts fixing the engine rpm and timing sensor.Fix the engine rpm and timing sensor electrical wiring to the bands.Fit the lower engine flywheel protection and fix it using the bolts. - 1076B52 exhaust pipe (one) leaving l/h or r/h exhaust manifold - r + r (left). - 7055B54 under-engine guard - r r . Connect the negative (-) battery terminal.Remove the vehicle from the ramp.