5540B46 LAMPADA ONE MAIN BEAM OR TURN SIGNAL LH OR RH OF ONE GAS DISCHARGE LIGHTING UNIT R R - Alfa - 166 - eLearn

3314883 - 5540B46 lampada one main beam or turn signal lh or rh of one gas discharge lighting unit r r

) Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 7040D12 engine front side cover (one) lh or rh - r r . 1. Disconnect the electrical connection from the exhaust gas headlamp control unit.

	Name	Connector
1	Left headlamp	F10

	Name	Connector
1	Right headlamp	F11

- 5540C40 motor (1), lh or rh, for correcting/aligning gas discharge light unit r r . For the main beam headlamp bulb1. Rotate the exhaust gas headlamp control unit in a clockwise direction to release it from the fastening on the light cluster and move it as far away as possible.2. Disconnect the electrical connection from the main beam bulb.

	Name	Connector
2	Left headlamp	F10

	Name	Connector
2	Right headlamp	F11

3. Rotate the bulb in an anti-clockwise direction and remove it.

If the lamp is working properly, avoid touching the bulb with your hands. If this does happen, clean the bulb with alcohol.

For the direction indicator bulb1. Rotate the exhaust gas headlamp control unit in a clockwise direction to release it from the fastening on the light cluster and move it as far away as possible.2. Disconnect the electrical connection from the direction indicator bulb.

	Name	Connector
2	Left headlamp	F10

	Name	Connector
2	Right headlamp	F11

3. Rotate the bulb in an anti-clockwise direction and remove it.

Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)

Refitting ( Removing

) Place the bulb back in its housing, rotating it in a clockwise direction and connect the electrical connection.Rotate the exhaust gas headlamp control unit in an anti-clockwise direction to fasten it to the light cluster. - 5540C40 motor (1), lh or rh, for correcting/aligning gas discharge light unit r r . Connect the electrical connection to the exhaust gas headlamp control unit. - 7040D12 engine front side cover (one) lh or rh - r r . Connect the negative (-) battery terminal - 5540B38 headlamp/light cluster light beam - position .