3314893 - 5540C46 sensor for correcting/aligning gas discharge lighting units on rear suspension - r r

Removing ( Refitting ) Position the vehicle on the ramp. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

	Name	Connector
-	Battery	A1B

1. Disconnect the electrical connection from the light cluster alignment rear sensor.

	Name	Connector
1	Rear xenon lamps sensor	K29

2. Undo the nut (2a) and disconnect the connecting rod (2b) from the light cluster alignment rear sensor.3. Undo the bolts (3a) and remove the mounting bracket (3b) complete with light cluster alignment rear sensor (3c).At the bench, undo the nuts and separate the light cluster alignment rear sensor from the bracket. Refitting ( Removing ) Fit the light cluster alignment rear sensor to the bracket and tighten the nuts.Place the mounting bracket, complete with light cluster alignment rear sensor, back in its housing and secure it by tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	LOWER TRACK CONTROL ARM MOUNTING BRACKET	M12	Rear suspension crossmember side 8.8 - 9.8

Connect the connecting rod to the light cluster alignment rear sensor and fasten it using the nut.Connect the electrical connection to the light cluster alignment rear sensor.Connect the negative (-) battery terminalRemove the car from the ramps. - 5540B38  headlamp/light cluster light beam - position .