3315097 - 7010M20 repeair side door electrically operated window motor - r r with door panel-mount frame removed
Removing
(
Refitting
)
- 7010A04 rear side door water
guard protection - r r or arrange with door panel removed1. Unscrew the nuts retaining the electrically-operated window
device to the door.2. Undo the clip retaining the window to to the electrically-operated
window device and remove the plastic pin.3. With the window fully raised, position a support hook to prevent
accidental lowering of the window.4. Disconnect the electrical connection. | Name | Connector |
|---|---|---|
| 4 | Rear right electric window motor | N66 |
| Name | Connector |
|---|---|---|
| 4 | Rear left electric window motor | N65 |
Refitting
(
Removing
)
Check the condition of the
device.Fit the electrically-operated window
device into the door.Tighten the nuts retaining the device to
the door.Connect the electrical connection.Check the device is working properly
by raising and lowering. Remove the support hookFit the window to the locating pin and
connect the retaining clip. - 7010A04 rear side door water guard protection - r r or arrange
with door panel removed