3315108 - 7025A10 bonnet lid - square
 | The full intervention including lid realignment is necessary only when car hinges have been removed. |
Removing
(
Refitting
)
- 7025A34 bonnet lid lock (one)
- r+r or repair - 7025A66 l/h or r/h bonnet lid support damper (one) - r+rHand-tighten the fasteners retaining the
hinges to the bonnet and car and then lower the bonnet lid.Check the gap is even and the lid is level
with the wings.1. With the aid of a second operator, open the bonnet lid to adjust
the gap and level the bonnet lid in relation to the wings. Permitted
adjustment movements are indicated by arrows.Close the bonnet and check it is properly
aligned.2. Carry out further adjustments if the position is found to be
incorrect and then tighten the fastenings to torque. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 2 | Bolt | BONNET LID HINGES | M8 | 2.4 |
Refitting
(
Removing
)
- 7025A34 bonnet lid lock (one)
- r+r or repair1. Adjust buffer blocks if necessary.2.
Adjust catch positon if necessary. Refer to op.
7025A34 bonnet lid lock (one) - r+r or repair
.
If the adjustments described above are
insufficient, adjust bonnet lid hinge position as described below.3. Loosen bolts (3a) securing hinges (3b) and adjust position until
the bonnet lid is aligned. Arrows (3c) indicate possible movements.4. Tighten bolts (3a) to the specified torque. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 3a | Bolt | BONNET LID HINGES | M8 | 2.4 |
