3308663 - K52 CODE FAILURE WARNING LIGHT ON

During starting, the CODE warning light.comes on and remains on for more than 0.7 seconds. (after carrying out the initial control unit test, the warning light should go out, ...)

		Results of the tests
0	PRELIMINARY CHECKS	All OK	Problems met	Operation
	Check the operation of the i.e. failure warning light	Continue to Step 1	The i.e. failure warning light also comes on and remains on	See table   K56
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Verify: that there are no faults in the CODE control unit	Continue to Step 2	An error is detected in the control unit	Continue following the instructions for the diagnostic equipment
			Lack of dialogue with the control unit	Restore the connection between the CODE control unit and the diagnostic connector ( See   E7010  CODE ).
2	HECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Search for the fault starting from another symptom'