1060F30 FUEL DELIVERY MANIFOLD - R R - Alfa - 166 - eLearn

3314360 - 1060F30 fuel delivery manifold - r r

) - 1060F36 lines to injectors - r r . 1. Disconnect the electrical connection from the fuel pressure sensor.

	Name	Connector
1	Fuel pressure sensor	K83

2. Undo the connector for the pipe from the pressure pump to the fuel manifold, manifold side, using a suitable spanner3. Undo the connector for the pipe from the pressure pump to the fuel manifold, pump side, using a suitable spanner.

	Name	Country
3b	Key	1.870.671.000

4. Remove the pipe from the pressure pump to the fuel manifold.

Fit a new high pressure pipe from the pressure pump to the fuel manifold upon reassembly.

5. Undo the nuts (5a) and remove the single fuel manifold pipe (5b).

Refitting ( Removing

) 1. Fit the single fuel manifold pipe (1a) and fix it using the nuts (1b).2. Fit a new pipe from the pressure pump to the fuel manifold and fix it using the connectors without tightening them.3. Tighten the connector for the pipe from the pressure pump to the fuel manifold, pump side, to the recommended torque using a suitable spanner.

The tightening torque figure in the table is the nominal value; therefore the correct value must be calculated according to the length of spanner N. 1.870.671.000.

	Fastening	Component	Ø	Value(daNm)
3	Connector	PRESSURE PUMP LINE TO FUEL MANIFOLD	M12	(Pressure pump side) 2.2

	Name	Country
3b	Key	1.870.671.000

4. Tighten the connector for the pipe from the pressure pump to the fuel manifold, fuel manifold side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
4a	Connector	PRESSURE PUMP LINE TO FUEL MANIFOLD	M14	(Fuel manifold side) 2.2

5. Connect the electrical connection to the fuel pressure sensor.

- 1060F36 lines to injectors - r r .