1820B15 HOSE FROM RIGID INTERMEDIATE PIPE TO MASTER CYLINDER (PUMP) - R R WITH PEDAL UNIT REMOVED FOR RIGHT HAND DRIVE VERSIONS - Alfa - 166 - eLearn

3314463 - 1820B15 hose from rigid intermediate pipe to master cylinder (pump) - r r with pedal unit removed for right hand drive versions

) Drain the brake-clutch fluid from the reservoir using a suitable syringe.Remove the driver side carpet.1. Undo bolts (1a), remove plastic pin (1b) and remove the under-facia lining driver side (1c).

Undo the nut and open the fuse access flap. 1. Undo bolt (1a) retaining cable link (1b), then remove the fuse access flap (1c).

1. Undo bolt (1a) and remove the integrated multiservice control unit (1b) after disconnecting electrical connections (1c).

For precise identification of the electrical connections, see Wiring Diagrams Section.

2. Undo the bolt (2a) and move the junction unit (2b).

1. Cut the band retaining the master cylinder cover and remove after releasing the pipe and electric wiring from the same bands.2. Disconnect and remove the hose from rigid supply pipe to clutch pump.

Refitting ( Removing

) Place the hose from rigid supply pipe to clutch pump back in its housing and connect it. Fit the master cylinder cover back in its seating and secure it with the bands.Connect the electrical connection and the pipe to the bands on the cover. Refit the junction unit in its seating and secure with its bolt.Connect the electrical connections to the integrated multiservices unit, then refit it in its seating and secure with its bolt.Place the fuse access cover back in its housing then secure the rod with the bolt.Close the fuse access flap and secure with the nut.Place the driver side under-facia wiring back in its seat then secure with the bolts and plastic pin.Put the driver side floor carpet back in place. - 1820B08 Clutch release HYDRAULIC SYSTEM - Bleeding air and restoring level