4130B58 HEAT EXCHANGER OR COIL - R.R. - Alfa - 166 - eLearn

3314648 - 4130B58 HEAT EXCHANGER or COIL - R.R.

) Position the vehicle on the ramp Proceed with removal - 7040D12 engine front side cover (one) lh or rh - r r (Left side). Proceed with removal - 7040D14 engine bay rear side cover (one) lh or rh - r r (Left side). 1. Undo the bolt (1a) and remove the bulkhead protection on the left side.2. Remove the power steering fluid reservoir cap and drain the fluid using a suitable syringe.

Proceed with removal - 7055B54 under-engine guard - r r . 1. Unscrew the bolts retaining the bumper to the radiator crossmember.

1. Use a suitable shim to move away the lower edge of the bumpers.2. Pull back protective sheaths (2a), unscrew connectors (2b) and disconect power steering system rigid hydraulic circuit pipes (duplex) from/to heat exchanger radiator (2c), heat exchanger side.3. Remove heat exchanger pipe (3a) after releasing it from mounting bands (3b).

Refitting ( Removing

) Place the heat exchanger pipe back in its housing and secure it using the mounting bands.Connect the power steering system rigid hydraulic circuit pipes (duplex) from/to heat exchanger radiator , heat exchanger side and tighten the fittings.Remove the shim used to move away the lower edge of the bumpers.Tighten the bolts retaining the bumper to the radiator crossmember. Proceed with refitting - 7055B54 under-engine guard - r r . Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	1.4

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times. Check and, if necessary, top up the fluid level in the reservoir. Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left). Top up the fluid level in the reservoir.Refit the service tank protection and secure with a bolt. Proceed with the refitting - 7040D14 engine bay rear side cover (one) lh or rh - r r (Left side). Proceed with the refitting - 7040D12 engine front side cover (one) lh or rh - r r (Left side).