5010A12 ENGINE/HEATER LINE - R R - Alfa - 166 - eLearn

3314722 - 5010A12 engine/heater line - r r

) Position the vehicle on the ramp. Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

1. Undo the drain plug in the radiator and drain the engine coolant.

Collect the coolant in a suitable container.

- 7040D12 engine front side cover (one) lh or rh - r r (left and right). - 7040D14 engine bay rear side cover (one) lh or rh - r r (left and right). - 5050B34 windscreen wiper arm/s complete with blade - r+r . - 7055A18 Windscreen base TRIM - R.R. . - 5050B38 windscreen wiper assembly - r+r or repair . 1. Disconnect the water supply pipe to the heater, heater side.

1. Disconnect the electrical connection from the engine coolant temperature sensor.

	Name	Connector
1	Data not available yet	K45

2. Disconnect the water supply pipe to the heater from the thermostat.

Refitting ( Removing

) Place the water supply pipe to the heater back in its housing. Connect the water supply pipe to the heater to the thermostat.Connect the electrical connection to the engine coolant temperature sensor. Connect the water supply pipe to the heater, heater side. - 5050B38 windscreen wiper assembly - r+r or repair . - 7055A18 Windscreen base TRIM - R.R. . - 5050B34 windscreen wiper arm/s complete with blade - r+r . - 7040D14 engine bay rear side cover (one) lh or rh - r r (left and right). - 7040D12 engine front side cover (one) lh or rh - r r (left and right). Supply the engine cooling system with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	ENGINE COOLING CIRCUIT	Alfa Romeo Climafluid Super Permanent -40°C	9.1

Connect the battery terminal (-).Remove the car from the ramp.