5520B12 STARTER MOTOR - R+R FOR VERSIONS WITH A/C - Alfa - 166 - eLearn

3314852 - 5520B12 starter motor - r+r for versions with a/c

) Position the vehicle on the lift. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

1. Disconnect the oil vapour recirculation pipe from the separator.2. Undo the nuts (2a) and move the oil vapour separator (2b) away from the air chamber.3. Recover the bracket.

Undo the upper two starter motor fixing bolts. - 7055B54 under-engine guard - r r . - 1084A16 oil dip stick pipe - r r . - 1076B50 exhaust pipe attachment to engine - r + r . 1. Disconnect the electrical connections from the starter motor.

	Name	Connector
1	Starter motor	A20

2. Undo the lower fixing bolt (2a) and remove the starter motor (2b).

Refitting ( Removing

) Fit the starter motor and fix it tightening the lower bolt to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STARTER MOTOR	M8	Gearbox side 2.3 - 2.8

Connect the electrical connections to the starter motor. - 1076B50 exhaust pipe attachment to engine - r + r . - 1084A16 oil dip stick pipe - r r . - 7055B54 under-engine guard - r r . Tighten the upper two bolts fixing the starter motor to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STARTER MOTOR	M8	Gearbox side 2.3 - 2.8

Place the vapour separator, complete with bracket, back in its housing and fix it to the air capacity body using the nuts.Connect the oil vapour recirculation pipe to the separator.Connect the negative (-) battery terminal.Remove the vehicle from the ramp.