7035B14 REAR WINDOW GLASS R R INCLUDES CLEANING OF HOUSING - Alfa - 166 - eLearn

3315167 - 7035B14 rear window glass r r includes cleaning of housing

) - 7055A10 MOULDING on roof panel (one), left or right - R.R. - 7025A26 bonnet lid opening control - repair1. Unscrew bolts (1a) retaining the lid to the hinges and move lid (1b) back as far as it will go. Then tighten the bolts again and protect the wing.2. Take out the upper part of the boot compartment seal

1. Remove the seal trim around the edge of the back window. 2. Protect the boot lid, wings and rear interior using covers then apply adhesive tape to protect the edges of the body in contact with the back window.

1. Working outside the car, use a vibrating cutter ( 1a) with blade (1b) to cut sealant strip (1c) around the edge of the back window.

	Name	Country
1a	Vibrating knife	1.823.011.000

	Name	Country
1b	Blade	1.823.022.000

2. Apply sucker handles (2a) to the back window and lift off with the aid of a second operator. Disconnect electrical connection (2b) to the back window and electrical connections between aerial control unit and back window (2c, 2d). Then remove the back window and rest it on a stand.

	Name	Connector
2b	Heated rear windscreen	P55

	Name	Connector
2c	Heated rear windscreen	P55

	Name	Connector
2d	Heated rear windscreen	P55

Refitting ( Removing

) Check that the window is undamaged.Check that the back window element is working properly and check operation if necessary.1. Fit locating pins.2. Degrease the screen printed area around the edge of the new window.3. Apply glass adhesion promoter (primer) (3b) to the screen printed area round the outside using applicator (3a) provided in the kit.

Wait for 15 minutes before carrying out the next operation to give the primer thinner time to evaporate.

1. Use vibrating knife (1a) and blade (1b) to cut and level the sealant strip in the back window compartment in order to leave 0.25 /1 mm thickness without scratching the paint and ensuring that locating holes (1c) in the upper corners of the compartment are left free. The sealant left in the housing will act as a backing for the new bond.2. Remove the tape and clean the back window housing carefully using compressed air and degrease thorougly using heptane.Touch up the paintwork if necessary.

	Name	Country
1a	Vibrating knife	1.823.011.000

	Name	Country
1b	Blade	1.870.691.000

1. Fit a new seal trim around the edge of the back window.Avoid touching the newly-treated screen-printed area.2. Use an air gun to extrude a sealant strip as evenly as possible around the edge of the back window. Begin applying the sealant from the middle of the lower edge and continue without any breaks around the entire edge of the back window.

1. With the aid of a second operator, connect the electrical connections and fit the back window.2. Fit retaining belt (2a) as shown in the figure and adjust belt tension to apply uniform pressure over the entire back window in order to ensure effective mating between glass (2b), sealant (2c) and back window (2d).

Do not move the car until the time specified by the sealant manufacturer has elapsed.

Check for leaks by applying soapy water around the outer edge and then blowing compressed air through from the inside.Refit the boot compartment seal. Unscrew the boot lid retaining bolts and reposition to align the boot. Refer to operation 7025B10 boot lid - square . - 7025A26 bonnet lid opening control - repair - 7055A10 MOULDING on roof panel (one), left or right - R.R.