3314382 - 1060G90 diesel injection wiring harness - r r

Removing ( Refitting ) Ensure that the ignition key is in stop position, then disconnect the battery negative terminal (  - 5530B10  battery - r+r ).

NameConnector
-Battery  A1B 
Proceed with the removal  - 7040D12  engine front side cover (one) lh or rh - r r (Right and left sides). Proceed with removal  - 7040D30  engine bay front beam cover - r r . Proceed with the removal  - 7040D14  engine bay rear side cover (one) lh or rh - r r (Right and left sides). 1. Connect the electrical connections to the diesel electronic injection control unit.

NameConnector
1Engine management control unit  M10A 
1. Disconnect the electrical connection from the cam angle sensor.

NameConnector
1Cam angle sensor  K47 
2. Disconnect the electrical connection.
1. Disconnect the electrical connection from the solenoid on the vacuum tank.

NameConnector
1Butterfly casing solenoid valve  L62 
1. Disconnect the electrical connection from the excess pressure sensor.

NameConnector
1Turbocharging sensor  K82 
2. Disconnect the electrical connection from the fuel pressure regulator.

NameConnector
2Fuel pressure regulator  N77 
3. Disconnect the electrical connection from the fuel pressure sensor.

NameConnector
3Fuel pressure sensor  K83 
1. Disconnect the electrical connection for the air conditioning compressor electromagnet coupling.

NameConnector
1Air conditioning compressor engagement electro-magnet  L20 
1. Disconnect the electrical connection from the turbocharger vane actuator solenoid.

NameConnector
1Variable geometry turbine fan  L36 
2. Disconnect the electrical connection from the engine coolant temperature sensor.

NameConnector
2Engine coolant temperature sensor-sender unit  K36 
1. Disconnect the electrical connections from the injectors.

NameConnector
1Injector  N70 
2. Remove the system wiring loom after disengaging it from the retaining collars.
Refitting ( Removing ) Place the cable loom back in its housing and fix it using the bands.Connect the electrical connections to the injectors.Connect the electrical connection to the engine coolant temperature sensor.Connect the electrical connection to the turbocharger vane actuator solenoid.Connect the electrical connection to the air conditioning compressor electromagnet coupling.Connect the electrical connection to the fuel pressure senor.Connect the electrical connection to the fuel pressure regulator.Connect the electrical connection to the excess pressure sensor.Connect the electrical connection to the solenoid on the vacuum tank.Connect the electrical connection.Connect the electrical connection to the cam angle sensorConnect the electrical connection to the diesel electronic injection control unit. Proceed with the refitting  - 7040D14  engine bay rear side cover (one) lh or rh - r r (Right and left sides). Proceed with the removal  - 7040D30  engine bay front beam cover - r r . Proceed with the refitting  - 7040D12  engine front side cover (one) lh or rh - r r (Right and left sides). Connect the negative (-) battery terminal.