3314466 - 1820B21 (Pump) - MASTER CYLINER R.R. for right hand drive versions
Removing ( Refitting ) Drain the brake-clutch fluid from the reservoir using a suitable syringe.Remove the driver side carpet.1. Undo bolts (1a), remove plastic pin (1b) and remove the under-facia lining driver side (1c).
Undo the nut and open the fuse
access flap. 1. Undo bolt (1a) retaining cable link (1b), then remove the fuse
access flap (1c).
1. Undo bolt (1a) and remove the integrated multiservice control
unit (1b) after disconnecting electrical connections (1c).
For precise identification of the electrical connections, see Wiring Diagrams Section. |
1. Cut the band retaining the master cylinder cover and remove after
releasing the pipe and electric wiring from the same bands.2. Disconnect the hose from the clutch reservoir to the master cylinder
on the master cylinder side.3. Disconnect the rigid delivery pipe from the master cylinder on
the master cylinder side.
1. Remove clip (1a) and take out pin (1b) connecting the master
cylinder to the pedal.2. Undo nuts (2a) and remove the clutch master cylinder (2b).
Refitting
(
Removing
)
1. Place the clutch master cylinder (1a) back in its housing and
fix it tightening the nuts (1b) to the recommended torque.2. Fit the master cylinder connection pin to the pedal and secure
with the clip.
1. Connect the rigid delivery pipe to the master cylinder, master
cylinder side, and tighten the connector to the specified torque.2. Connect the hose from the clutch reservoir to the master cylinder
on the master cylinder side.3. Fit the master cylinder cover back in its seating and secure
it with the bands.4. Connect the electrical connection and the pipe to the bands on
the cover.
Refit the junction unit in
its seating and secure with its bolt.Connect the electrical connections to the
integrated multiservices unit, then refit it in its seating and
secure with its bolt.Place the fuse access cover back in its
housing then secure the rod with the bolt.Close the fuse access flap and secure with
the nut.Place the driver side under-facia wiring
back in its seat then secure with the bolts and plastic pin.Put the driver side floor carpet back in
place. - 1820B08 Clutch release HYDRAULIC SYSTEM - Bleeding air and
restoring level