3314641 - 4130B38 power steering pump inlet pipe from fluid resevior pipe or intermediate rigid pipe r r

Removing ( Refitting ) Position the vehicle on the ramp Proceed with the removal  - 7040D12  engine front side cover (one) lh or rh - r r (Left side). Proceed with the removal  - 7040D14  engine bay rear side cover (one) lh or rh - r r (Left side). 1. Undo the bolt (1a) and remove the bulkhead protection on the left side.2. Remove the power steering fluid reservoir and drain the fluid using a suitable syringe.
1. Disconnect the power steering pump feed hose, power steering pump side.
1. Disconnect the power steering pump feed hose, rigid pipes side, and remove the hose.
Refitting ( Removing ) Fit the power steering feed hose and connect it to the rigid pipes.Connect the power steering pump feed hose, steering pump side.Fit the bulkhead protection on the left side and secure it with its bolt. Proceed with the refitting  - 7040D14  engine bay rear side cover (one) lh or rh - r r (Left side). Proceed with the refitting  - 7040D12  engine front side cover (one) lh or rh - r r (Left side). Fill the power steering circuit with the recommended fluid.

TypeComponentNameQty.
-Fluid [l]POWER ASSISTED STEERING CIRCUITTUTELA GI/A1.4
Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times. Check and, if necessary, top up the fluid level in the reservoir. Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left). Top up the fluid level in the reservoir.