7025B10 BOOT LID - SQUARE - Alfa - 166 - eLearn

3315121 - 7025B10 boot lid - square

) Lift the boot lid.1. Loosen hinge bolts (1a) and adjust the boot lid position.Arrows (1b) indicate permitted movements.Tighten the hinge retaining bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BOOT LID HINGES	M6	0.8

2. Adjust the buffer blocks if necessary.

If the adjustments described previously are insufficient, adjust boot lid hinge position as described below. - 7025B58 boot lid lock striker - r+r

Refitting ( Removing

) 1. Remove the sealant, loosen hinge bolts (1a) and adjust boot lid position.Arrows (1b) indicate possible movements.Check that the boot lid is aligned.Tighten the bolts retaining the hinge to the body. Complete op. 7025B58 boot lid lock striker - r+r

	Fastening	Component	Ø	Value(daNm)
1a	Bolt	BOOT LID HINGES	M8	2.4

Test the boot lid works properly and is correctly aligned.Replace the sealant between hinges and body.If necessary, touch up the paintwork in the hinge area.