3310B36 REAR BRAKE CALLIPER - R R - Alfa - 166 - eLearn

3314558 - 3310B36 rear brake calliper - r r

) Position the vehicle on the ramp.Remove the handbrake boot.1. Lift up the handbrake lever (1a) and loosen the nut (1b) tensioning the handbrake cables.

- 4450B11 WHEEL (one) rear - R.R. . 1. Disconnect the handbrake cable from the rear brake caliper.

1. Disconnect the rear brake caliper flexible pipe, rigid pipe side.2. Remove the clip (2a) and release the rear brake caliper flexible pipe (2b) from the mounting bracket.

1. Undo the bolts (1a) and remove the rear brake caliper (1b) complete with flexible pipe (1c).2. Remove the brake pads.

Refitting ( Removing

) 1. Compress the rear brake caliper piston (1a) using the tool (1b) to facilitate the refitting of the brake caliper.

	Name	Country
1b	Key	1.822.108.000

Fit the rear brake caliper complete with pads and flexible pipe and tighten the bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR BRAKE CALIPER	M14	(Bracket side) 2.5 - 3.0

Connect the rear brake caliper flexible pipe to the mounting bracket and secure using its clip.Connect the rear brake caliper flexible pipe to the rigid pipe and tighten the connector to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	HOSE TO REAR BRAKE CALIPER	M10	Rigid pipe side 1.5 - 1.9

Connect the handbrake cable to the rear brake caliper. - 3380A04 handbrake - check travel . - 4450B11 WHEEL (one) rear - R.R. . - 3330A10 BRAKE FLUID - Check level and top up, if necessary. . - 3330A14 HYDRAULIC BRAKING SYSTEM - Bleed air . Remove the car from the ramp.