3314688 - 4420C10 rear suspension stabilizer bar - r+r

Removing ( Refitting ) Position the vehicle on the lift. - 4450B13  rear wheels(2) r r . 1. Release the rear brake caliper flexible pipes from the mounting brackets.2. Release the wiring for the rear wheel rpm sensors on the mounting brackets.3. Undo the nuts (3a) and disconnect the joints (3b) from the rear suspension anti-roll bar. 1. Position a hydraulic jack under the rear suspension crossmember.2. Undo the bolts (2a) and lower the rear suspension crossmember (2b), as necessary, using the hydraulic jack. 1. Undo the bolts (1a) and remove the anti-roll bar (1b). Refitting ( Removing ) 1. Fit the anti-roll bar (1a) and fix it tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	REAR ANTI-ROLL BAR	M8	Rear suspension crossmember side 2.3 - 2.5

1. Replace the rear suspension crossmember (1a) in its housing using the hydraulic jack (1b) and fix it tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	REAR CROSS-BEAM	M10	Bodyshell side 4.7 - 5.1

Remove the hydraulic jack from under the crossmember. 1. Connect the joints (1a) to the rear suspension anti-roll bar and fix them tightening the nuts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Nut	REAR ANTI-ROLL BAR PIVOTS	M10	Anti-roll bar side 4.3 - 4.7

2. Fix the wiring for the rear wheel speed sensors to the mounting brackets.3. Fix the rear brake caliper flexible pipes to the mounting brackets.  - 4450B13  rear wheels(2) r r . Remove the vehicle from the ramp.