3315153 - 7030B45 cable - r r

Removing ( Refitting ) Move the motor pinion pin by hand to slide open the sun-roof sheet steel panel partially.Release the lower blind from the panel and push back until the anchorage clips can be heard to click.Move the motor pinion pin by hand until the sun-roof sheet steel panel is open in tilted position.Move the blind fully back.1. Unscrew the bolts retaining the panel to the chassis.2. Remove the panel.3. Unscrew bolts (3a) retaining motor (3b) to the chassis in order to release the control cables.4. Disconnect pins (4a) of drainage channel (4b) from the guides.5. Remove the channel from the guides.6. Unscrew the rear end stop bolt.7. Remove the sealant between the water drainage terminal and the guide.8. Remove the water drainage terminal.9. Move the slide backward until the cable can be disconnected.Withdraw the control cable. Refitting ( Removing ) Check that the control cable is undamaged.Thread the control cable into the sliding seat.Connect the control cable to the slide.Refit the exhaust tail-pipe.Apply polyurethane sealant to the exhaust tail-pipe, then level to prevent water entering.Tighten the end stop screw.Fit the channel into the guides.Fit the channel pins into the guides.1. Working on both guides, move slides (1a) by hand fully forward to the end of their travel (1b) (tilted open position). 1. Before refitting the motor, connect it to connection (1a) and turn cam (1b) to point S where it is aligned with microswitch (1c).Turn the cam anticlockwise so that it passes through point C first. Fit the motor and secure with bolts.Fit the panel and screw in bolts without tightening.Move the motor pinion pin by hand until the panel is in closed position.Check the sun-roof is working properly.