1820B54 HOSE FROM DAMPER - R R - Alfa - 166 - eLearn

3314472 - 1820B54 hose from damper - r r

) Proceed with removal - 7040D12 engine front side cover (one) lh or rh - r r (Left side). Proceed with removal - 7040D14 engine bay rear side cover (one) lh or rh - r r (Left side). Unclip the coolant outlet pipe from the reservoir.1. Undo the bolt (1a) and move aside the coolant reservoir (1b).

1. Remove the cap on the bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the hydraulic clutch actuator. 3. Lift the retaining clip (3a) and withdraw the bleed device (3b) as much as necessary.Let the hydraulic clutch system drain completely.4. Raise retaining clip (4a) and disconnect the hose from the vibration damper to the slave cylinder (4b), clutch hydraulic actuator side.

1. Undo the connector and disconnect the flexible pipe from the vibration damper to the operating cylinder, damper side.2. Remove the flexible pipe from the vibration damper to the slave cylinder after having released it from its fastenings.

Refitting ( Removing

) Place the flexible pipe from the vibration damper to the slave cylinder back in its housing and secure it.Connect the pipe from the vibration damper to the operating cylinder, damper side and tighten the connector to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	HOSE FROM VIBRATION DAMPER	M12	(Damper side) 1.7 ÷ 1.9