4130A10 POWER STEERING BOX - R+R - CHECK TOW-IN IF NECESSARY SEPARATELY - INCLUDES BLEEDING - Alfa - 166 - eLearn

3314632 - 4130A10 power steering box - r+r - check tow-in if necessary separately - includes bleeding

) Place the car on a ramp with the wheels perfectly straight.Mark the position of the steering wheel in relation to the upper steering column shroud. - 7040D12 engine front side cover (one) lh or rh - r r (left). - 7040D14 engine bay rear side cover (one) lh or rh - r r (left). 1. Undo the bolt (1a) and remove the bulkhead protection on the left side.2. remove the power steering fluid reservoir cap and drain the fluid using a suitable syringe.

1. Disconnect the connector on the delivery pipe from pump to steering box to facilitate refitting.

- 1076B70 exhaust pipe between pre-catalytic converter and catalytic converter - r r (right).

Refitting ( Removing

) Refit the power steering box in its seating, working from the front right wheelarch.Tighten the nuts securing the power steering heat exchanger pipe to the body shell.1. Tighten the bolts securing the power steering box to the front suspension subframe to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1	Nut	POWER STEERING BOX	M12	Front suspension frame side 10.5 - 11.5

2. Connect the delivery pipe from pump to power steering box, steering box side, and tighten its connector to the specified torque.

	Fastening	Component	Ø	Value(daNm)
2	Connector	PIPE BTWN PUMP + POWER STEERING BOX	M16	(Power steering box side) 3.4 ÷ 3.8

- 1076B70 exhaust pipe between pre-catalytic converter and catalytic converter - r r (right). Connect the pipe from pump to power steering box, pump side, and tighten the connector to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	PIPE BTWN PUMP + POWER STEERING BOX	M16	(Power steering pump side) 3.8 ÷ 4.2

1. Tighten the bolt securing the bracket for the delivery pipe from pump to power steering box.2. Connect the outlet hose from the power steering box (2a), steering box side, and tighten the connector (2b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
2b	Connector	POWER STEERING/EXCHANGE BOX RUBBER HOSE	M12	(Power steering box side) 3.2 ÷ 3.6

Fit the protection and bolt in place.Fit the fail-safe device on the power steering box pinion.Connect the steering column to the steering box pinion and tighten the new bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STEERING SHAFTS	M8	(Power steering box pinion side) 2.8 - 3.2

Fit the steering column universal joint guard and secure it with its nuts.Put the floor carpet back in place.Fit the accelerator pedal travel stop complete with rubber protector.