3314701 - 4450A40 rear wheel geometry - check using optical equipment

The figure shows the points for measuring dimensions C and D for calculating the wheel geometry.

If the rear wheel geometry is not within specified limits, replace both rear suspension springs.

The figure shows the points for measuring dimensions D2 and D1 to calculate the toe-in. Up to chassis no. 22265, the rear wheel toe-in values are as shown in the table.

	Measurement		Value
-	D2 - D1 (mm)		5.5 ± 1
	(Unladen vehicle filled with fluids) (-)	-

From chassis no. 22266, the rear wheel toe-in values are as shown in the table.

	Measurement		Value
-	D2 - D1 (mm)		3.0 ± 1
	(Unladen vehicle filled with fluids) (-)	-

If the rear wheel toe-in value is not within specified limits then adjust it using the rods.

The figure shows the angle for measuring the camber. Up to chassis no. 28533, the non-adjustable rear wheel camber values are shown in the table.

	Measurement		Value
-	- (-)		23' ± 20?
	(Unladen vehicle filled with fluids) (-)	-