3314895 - 5540C50 control unit for correcting/aligning gas discharge lighting unit - r r

Removing ( Refitting ) Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

	Name	Connector
-	Battery	A1B

Move the front driver's seat forwards.Cut the floor covering along the area marked.1. Extract the control unit for the exhaust gas light cluster alignment system from the support guide.2. Disconnect the electrical connection from the exhaust gas headlamp alignment system control unit, then remove it.

	Name	Connector
2	Xenon headlamps control unit	M87

Refitting ( Removing ) Connect the electrical connection to the exhaust gas light cluster alignment system control unit, then place it back in its housing.Place the front driver's seat back in position.Connect the battery terminal (-).

If the exhaust gas light cluster alignment system control unit is being replaced, the control unit self-learning procedure must be carried out using the Examiner.

 - 5540B38  headlamp/light cluster light beam - position .