1060G42 CLUTCH PEDAL SWITCH - R R - Alfa - 166 - eLearn

3314375 - 1060G42 clutch pedal switch - r r

) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Remove the sound-proofing protection.Disconnect the electrical connection from the switch on the clutch pedal.

	Name	Connector
-	Clutch pedal switch	I31

Turn the switch clockwise through 90 degrees and remove.

Refitting ( Removing

) Press the clutch pedal, then refit the clutch pedal switch and turn through 90 degrees anticlockwise until it clicks home on the detent ridge. Release the clutch pedal and pull back to the end of its travel (rest position).

If the switch is not fully back, it could hold the clutch pedal in an advanced position.

Press the clutch pedal through its full travel to allow the switch to settle. Connect the electrical connection to the switch on the clutch pedal. Place the rubber protection back in its housing.Connect the negative (-) battery terminal.