3315168 - 7035B18 Windscreen GLASS - Eliminate water penetration

Removing ( Refitting )  - 7025B26  l/h or r/h boot lid lift device (one) - r+r - 7055A10  MOULDING on roof panel (one), left or right - R.R.1. Unscrew bolts (1a) retaining the lid to the hinges and move lid (1b) back as far as it will go. Then tighten the bolts again and protect the wing.2. Take out the upper part of the boot compartment seal 1. Remove the seal trim around the edge of the back window. Protect the boot lid, wings and rear interior using covers then apply adhesive tape to protect the edges of the body in contact with the back window.2. Check for leaks by applying soapy water around the outer edge and then blowing compressed air through from the inside. After ascertaining the lcoation of the leak, remove the corresponding inner part covering the edge of the back window.If the leak is small, seal the relevant part from the inside and wait for the sealant to dry. Then repeat the test. Refitting ( Removing ) If the leak is more extensive, refer to op.   7035B10  Rearscreen (bonded type) WINDOW GLASS - R.R. - Includes. cleaning edges of glass and housing in bodyshellRefit the outer seal. Unscrew the boot lid retaining bolts and reposition to align the boot. Refer to operation   7025B10  boot lid - square .  - 7055A10  MOULDING on roof panel (one), left or right - R.R. - 7025B26  l/h or r/h boot lid lift device (one) - r+r