3315186 - 7040A97 facia trim support beam - r r

Removing ( Refitting ) - 5580M10 on-board navigator panel unit - r r  - 5505A18  multi-function control unit - r r - 5580E12  immobiliser device ecu - r+r following electric circuit check - 5010D30  passenger compartment air temperature sensor - r+r following electrical wiring check operation - 5540A22  exterior lighting control switch - r+r - 7040A44  facia lh side cover - r r - 7040A45  facia rh side cover - r r - 5580C26  LOCK BARREL KEY/SWITCH for deactivating passenger 'AIR BAG - R.R. - 5010C30  central air outlet on fascia - r+r - 5560B11  analogue control panel - r+r or replace - 7040A26  steering column trim - r+r- 5550C16 hazard warning light/fog lamp/reversing light combined switch - r r - 5040D18 air conditioner control unit - r r - 5570T80 car radio unit - r+r  - 7065C42  ashtray (one) r+r- 5570T80 car radio unit - r+r  - 7065C42  ashtray (one) r+r - 5580C18  air bag module - r+r - 1056B79  injection/ignition contro unit guard - r r - 4110A11  steering wheel - r+r for replacement or check for versions with air bag - 5550A12  complete stalk unit - r+r for versions with air bag - 7040A31  flap assembly - r r - 7040G24  switch for facia compartment light - r+r - 5580C22  AIR BAG MODULE - Passenger side - R.R. - 7040A67  partition between passenger airbag and facia compartment - r r - 7040A43  cover (one only) for wiring beneath facia - r r- 5505C32 (one) securing wiring connectors beneath instrument facia - r r  - 5580C14  air bag ecu - r+r - 7040L20  tunnel trim - r r- 7045A10 l/h or r/h front seat (one) - r+r Pull up the floor carpet.1. Uncrew the three bolts retaining the joint cover to the body.2. Remove the joint cover.3. Unscrew the bolts retaining the steering column to the steering box pinion.4. Move the steering column joint back.
1. Remove the connector safety protection (1a) and disconnect door wiring connector (1b).2. Use tool (2a) to unscrew retaining bolts (2b). Then disconnect half-connector (2c) from its seat on the body. Carry out the same operation on both front doors.

NameConnector
1BDriver's front door rear. section.  D30 

NameCountry
2aKey1.822.132.000
1. Disconnect electrical connection (1a) between engine wiring and facia wiring, electrical connection (1b) between facia wiring and roof wiring - and electrical connection (1c) between facia wiring and rear service wiring.2. Release airbag wiring sections secured to the facia wiring from the retaining collars.3. Disconnect electrical connectors (3a) and (3b).4. Unscrew upper nut (4a) securing the steering column strut and remove strut (4b).

NameConnector
1aDashboard-i.e coupling.  D1 

NameConnector
1bDashboard-courtesy lights coupling  D42 

NameConnector
1cDashboard-left rear coupling  D25 

NameConnector
3aBrake pedal switch  I30 

NameConnector
3bClutch pedal switch  I31 
1. Remove the radiant element from the heater unit and move to one side. Take care not to damage the two coolant pipes.
1. Unscrew the nuts retaining the facia frame to the body.2. With the aid of a second operator, remove the frame complete with air distributor box, steering column and facia wiring.
Refitting ( Removing ) Fit the facia frame to the body. Take care to refit the facia wiring correctly.Tighten the nuts retaining the frame to the body to the specified torque.Fit the radiant element in its seat in the heater/air conditioner unit housing.Fit the steering column strut.Tighten the upper strut retaining nut.Connect the electrical connection, pull through the airbag electrical lead and replace the retaining collar.Connect the electrical connection betwen engine wiring and facia wiring, the electrical connection between facia wiring and roof wiring - and the electrical connection betwen facia wiring and rear service wiring.Fit the door wiring into its seat and secure the half-connector to the body using the tool shown.

NameCountry
-Key1.822.132.000
Connect the front door wiring electrical connector and refit the protection.Fit the steering column joint.Tighten the steering column retaining bolt.Position the steering wheel so that it is straight.Tighten the three nuts retaining the joint cover to the body.Fit the floor carpet.- 7045A10 l/h or r/h front seat (one) - r+r  - 7040L20  tunnel trim - r r - 5580C14  air bag ecu - r+r- 5505C32 (one) securing wiring connectors beneath instrument facia - r r  - 7040A43  cover (one only) for wiring beneath facia - r r - 7040A67  partition between passenger airbag and facia compartment - r r - 5580C22  AIR BAG MODULE - Passenger side - R.R. - 7040G24  switch for facia compartment light - r+r - 7040A31  flap assembly - r r - 5550A12  complete stalk unit - r+r for versions with air bag - 4110A11  steering wheel - r+r for replacement or check for versions with air bag - 1056B79  injection/ignition contro unit guard - r r - 5580C18  air bag module - r+r - 7065C42  ashtray (one) r+r- 5570T80 car radio unit - r+r - 5040D18 air conditioner control unit - r r - 5570T80 car radio unit - r+r  - 7065C42  ashtray (one) r+r- 5550C16 hazard warning light/fog lamp/reversing light combined switch - r r  - 7040A26  steering column trim - r+r - 5560B11  analogue control panel - r+r or replace - 5010C30  central air outlet on fascia - r+r - 5580C26  LOCK BARREL KEY/SWITCH for deactivating passenger 'AIR BAG - R.R. - 7040A45  facia rh side cover - r r - 7040A44  facia lh side cover - r r - 5540A22  exterior lighting control switch - r+r - 5010D30  passenger compartment air temperature sensor - r+r following electrical wiring check operation - 5580E12  immobiliser device ecu - r+r following electric circuit check - 5505A18  multi-function control unit - r r- 5580M10 on-board navigator panel unit - r r