3380A10 HANDBRAKE LEVER - R+R - Alfa - 166 - eLearn

3314618 - 3380A10 handbrake lever - r+r

) Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 7040L20 tunnel trim - r r . 1. Undo the adjustment nut (1a) and remove the retaining spring (1b).2. Lift up the handbrake lever and release the linkage from the lever.

1. Disconnect the electrical connection from the handbrake "on" warning light switch.

	Name	Connector
1	Handbrake "on" switch	I40

2. Undo the nut (2a) and disconnect the earth cable (2b) from the handbrake lever.

	Name	Connector
2b	Data not available yet	-

3. Undo the stud (3a) and remove the handbrake "on" warning light switch (3b).

1. Undo the bolts (1a) and remove the handbrake lever (1b).

Refitting ( Removing

) Fit the handbrake lever and tighten the bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	HANDBRAKE LEVER	-	Support side -

Fit the handbrake "on" warning light switch and secure with its stud.Connect the earth lead to the handbrake lever and secure with its nut.Connect the electrical connection to the handbrake "on" warning light switch.Lift up the handbrake lever and refit the linkage in its seating on the lever.Fit the retaining spring and tighten the adjustment nut. - 3380A04 handbrake - check travel . - 7040L20 tunnel trim - r r . Connect the negative (-) battery terminal.