2753373 - 1020A14 crank case oil sump - r + r and replace gasket with engine removed

Removing ( Refitting ) 1. Undo the nuts (1a) and the bolts (1b) and remove the engine block sump (1c).

To facilitate removal of the sump from the engine block, heat the sealant with a body drier.

Refitting ( Removing ) Clean any sealant residues from matching surfaces of sump and engine block.1. Apply an unbroken strip of the recommended sealant to the entire perimeter of the crankcase sump as shown in the figure.

Ensure a perfect join between start and end section.

	Type	Component	Name	Qty.
1	Silicon sealant	PISTON SET	LOCTITE 5900	-

2. Refit crankcase sump (2a) and secure by tightening bolts (2b) and nuts (2c) to the specified torque.

When fitting the crankcase sump, avoid major sideways movements which may remove the sealant.

Wait at least 1 hour after fitting the engine block sump before replenishing it with engine oil.

	Fastening	Component	Ø	Value(daNm)
2b	Bolt	OIL SUMP	M6	(Oil sump) 0.8

	Fastening	Component	Ø	Value(daNm)
2c	Nut	OIL SUMP	M6	(Oil sump) 0.8