169000411 - Z102 SIDE AIRBAG FAILURE
 | When applying this procedure, always consider the following: |
- Measurements cannot be carried out on the airbag wiring.
- Begin testing the system with the vehicle appliances still connected.
- The fault must be "Present" or "Present Intermittently" and not "Intermittent". In the event of an Intermittent fault, the Procedure is not applicable. Check the line where the fault was reported carefully.
- Not all the simulation sensors are available (e.g. side impact sensors).
 | The airbag fault warning light is controlled by a dedicated connection to the airbag control unit Instrument Panel Node. |
 | The airbag wiring is a safety component. If faults occur in the wires or connectors, all the wiring must be replaced. |
| 1 | CHECK THE LEFT SIDEBAG | All OK | Problems encountered | Operation |
|---|---|---|---|---|
| Turn the key to OFF.Disconnect the faulty sidebag from the wiring and connect a dummy resistance in its place.Turn the key ON and activate communication.Check whether the fault in that sidebag has become intermittent | Move on to Step 2 | The fault is still present | Turn the key to OFF.Replace the rear wiringClear the errors using the diagnostic tester and proceed to step 3 | |
| 2 | REPLACE THE SIDE BAG | All OK | Problems encountered | Operation |
| Turn the key to OFF.Replace the sidebag Op. 5580C44 FRONT SIDE BAG MODULE ONE LH OR RH R RClear the errors using the diagnostic tester | Move on to Step 3 | |||
| 3 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
| Check that the tester does not indicate other faults | End of diagnosis | The diagnostic tester reports other faults | Proceed as instructed in the See table K80 AIRBAG FAILURE WARNING LIGHT ON |