| 1 | CLUTCH PEDAL SWITCH OPERATION CHECK | All OK | Problems encountered | Operation |
|---|
| Connect the Examiner, enter into the fault diagnosis in the "PARAMETERS" ambient (Engine management) and check the "CLUTCH PEDAL STATUS" parameter.Press the clutch pedal and read "PRESSED".Release the clutch pedal and read "RELEASED" | Move on to Step 4 1 | Incorrect reading | Replace the sensor.Move on to Step 2 1 |
| 2 | CLUTCH SWITCH CHECK | All OK | Problems encountered | Operation |
|---|
| Detach the connector for the switch and check its operation | Move on to Step 2 1 | The switch is not working properly | Replace the switchMove on to Step 4 1 |
| 3 | ELECTRICAL CONNECTION CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electrical continuity between the clutch switch and the engine management control unit. | Move on to Step 4 1 | Electrical continuity failure between the switch and the engine management control unit | Restore the connection.Move on to Step 4 1 |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Road test the vehicle to check that the system is working properly | End of diagnosis | | |
