| | Results of the tests |
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect
the EXAMINER diagnostic equipment and check that there are no faults
at the Air Bag control unit | Continue to Step 2 | Presence of fault in warning
light/belt switch | Continue as instructed by the tester |
| 2 | CHECKING WARNING LIGHT OPERATION | All OK | Problems met | Operation |
|---|
| With
the ignition key turned off, disconnect the airbag control unit,
turn the key to ON and check the warning light is off | Continue to Step 4 | warning light on | Continue to Step 3 |
| 3 | CHECKING ELECTRICAL EQUIPMENT | All OK | Problems met | Operation |
|---|
| Check
the insulation of the warning light control lead from air bag control
unit to the instrument panel. See E7030 AIRBAG | Continue to Step 5 | cable short circuited
to earth; | Replace wiring See E7030 AIRBAG |
| 4 | Continue as instructed by
the tester | All
OK | Problems
met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | Replace air bag control unit Op. 5580C14 |
| 5 | Continue as instructed by
the tester | All
OK | Problems
met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | Replace air bag control unit Op. 5560B11 |
