2752740 - 3330D14 brake servo - r+r for versions with abs - includes separation from master cylinder (pump)
Removing
(
Refitting
)
- 3330C34 brake fluid reservoir
- r + r and wash inside - versions with r/h drive and abs - 5530B10 battery - r+r - 5530B56 BATTERY DRIP TRAY COVER - R.R. - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. - 1048A10 air cleaner filtering element - replace - 3330C14 (PUMP) - MASTER CYLINDER .R.R for versions with A.B.S. - 3340A12 A'B.S. system. - electronic and hydraulic CONTROL
UNIT R.R.1. Move the brake pedal to disengage the two retainers locking the
brake servo pushrod, then release the pushrod from the brake pedal. | After each dismantling operation the retaining device must always be replaced even if it appears to be intact. |
Refitting
(
Removing
)
Fit the brake servo/brake pump
assembly in the engine compartment.Connect the vacuum pipe to the connection
on the single-acting valve on the brake servo.Fit the new retaining device onto the
brake pedal to secure the retaining clips. Move the brake servo back slightly, lift
up the brake pedal and position the brake servo push rod by the retaining
device.Press the brake pedal to engage the brake
servo push rod with the retaining device.Tighten the nuts securing the pedal assembly
to the brake servo. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| - | Nut | BRAKE SERVO | M8 | 2.2 |