2752748 - 3330E51 rigid pipe (one), lh or rh, from master cylinder to fitting - r r
Removing
(
Refitting
)
Place the car on a ramp.Remove the protective cap on the brake
caliper bleed valve.Connect the collection system (pipe and
reservoir) to the bleed valve on the brake caliper.Operate the brake pedal until the brake
fluid reservoir is empty. - 5530B10 battery - r+r1. Unscrew the rigid pipe connector from the braking compensator.Release the brake pipe from the upper plastic
clips.
Raise the lift.1. Open the brake pipe retaining clip.
1. Undo the fixing bolts (1a) and remove retaining clip (1b).2. Remove the front section fo the rigid brake pipe and fuel pipe
protection.
1. Undo the connector on the rigid pipe from the master cylinder,
lower the lift and remove from the upper part of the engine compartment.
Refitting
(
Removing
)
Fit the rigid pipe from master
cylinder to connector.Tighten the connector to the rigid intermediate
section of the rear brake pipe to torque.
Fastening
Component
Ø
Value(daNm)
-
Connector
BRAKING SYSTEM FITTING/S
M10
1.6
Fit the front section of the rigid brake
pipe and fuel pipe protection and tighten the front side bolts and clip.Secure the rigid pipe from master cylinder
to connectors to the lower body fastening clip.Tighten the rigid pipe connector to the
braking compensator to torque.
Removing
(
Refitting
)
Place the car on a ramp.Remove the protective cap on the brake
caliper bleed valve.Connect the collection system (pipe and
reservoir) to the bleed valve on the brake caliper.Operate the brake pedal until the brake
fluid reservoir is empty. - 5530B10 battery - r+r1. Unscrew the rigid pipe connector from the braking compensator.Release the brake pipe from the upper plastic
clips.
