2752802 - 4410c10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Place the car on a ramp. - 4450B12  front or rear wheels (two) - r+r1. Undo the bolts securing the steering box to the crossmember.2. Undo the bolts fixing the U-bolts securing the anti-roll bar to the suspension crossmember.
1. Undo the fixing bolts (1a) and (1b), then remove the lower reaction rod (1c).
1. Undo the left and right nuts securing the anti-roll bar to the anchorage rods.
1. Position a hydraulic jack underneath the suspension crossmember.2. Undo the bolts fixing the front suspension crossmember to the bodyshell.Lower the suspension frame slowly.3. Remove the anti-roll bar via the right wheel arch.
Refitting ( Removing ) Fit the anti-roll bar via the right wheel arch.
The flexible mountings should not show signs of deterioration, like the anti-roll bar, or else the mountings and the actual anti-roll bar will have to be replaced.
Raise the suspension crossmember using the supporting device.Tighten the bolts fixing the suspension crossmember to the bodyshell to torque.

FasteningComponentØValue(daNm)
-BoltFRONT SUSPENSION SUBFRAMEM12 x 1.258
Tighten the bolts for the left and right U-bolts fixing the anti-roll bar to the crossmember to torque.

FasteningComponentØValue(daNm)
-BoltFRONT ANTI-ROLL BARM8(Crossmember) 2.3
Tighten the nuts fixing the anti-roll bar to the anchorage rods to torque.

FasteningComponentØValue(daNm)
-BoltFRONT ANTI-ROLL BARM8(Rods) 2.3
Tighten the bolts fixing the steering box to the crossmember to torque.

FasteningComponentØValue(daNm)
-BoltSTEERING BOX (RACK AND PINION)M12 x 1.258
Fit the lower reaction rod and tighten the bolts fixing it to the crossmember and to the gearbox.

FasteningComponentØValue(daNm)
-BoltPOWER UNIT BOTTOM REACTION RODM12 x 1.25(Crossmember side) 8

FasteningComponentØValue(daNm)
-BoltPOWER UNIT BOTTOM REACTION RODM12 x 1.25(Gearbox side) 8
 - 4450B12  front or rear wheels (two) - r+r . Lower the left and remove the vehicle.