4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED - Fiat - PANDA - eLearn

2752806 - 4410D14 front suspension crossbeam - r+r with wishbones removed

) - 1048A10 air cleaner filtering element - replace - 1072C44 exhaust manifold heat shield on bulkhead - r+r1. Undo the nuts securing the exhaust manifold to the cylinder head.Move the exhaust manifold away from the cylinder head until it is released from the studs on the cylinder head.

1. Undo the bolts fixing the lower engine reaction rod.2. Remove the lower engine reaction rod.3. Undo the bolt fixing the mounting bracket for the first section of the exhaust pipe.Lower the first section of the exhaust pipe.

1. Undo the bolts securing the steering box to the crossmember.2. Undo the bolts fixing the U-bolts securing the anti-roll bar to the suspension crossmember.Position a hydraulic jack underneath the suspension crossmember.3. Undo the bolts fixing the crossmember to the bodyshell.4. Remove the suspension crossmember.

Refitting ( Removing

) Position the suspension crossmember on a hydraulic jack.Raise the hydraulic jack and place the crossmember near the mountings on the bodyshell.Tighten the bolts fixing the crossmember to the bodyshell to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT SUSPENSION SUBFRAME	M12 x 1.25	8

Remove the hydraulic jack.Tighten the bolts securing the the steering box to the suspension cross member to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER UNIT BOTTOM REACTION ROD	M12 x 1.25	(Crossmember side) 8

Tighten the bolts for the left and right U-bolts fixing the anti-roll bar to the crossmember to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT ANTI-ROLL BAR	M8	(Crossmember) 2.3

Fit the lower reaction rod and tighten the bolts fixing it to the crossmember and to the gearbox to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER UNIT BOTTOM REACTION ROD	M12 x 1.25	(Crossmember side) 8

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER UNIT BOTTOM REACTION ROD	M12 x 1.25	(Gearbox side) 8

Place the exhaust manifold in position on the cylinder head, then tighten the fixing nuts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	EXHAUST MANIFOLD/S	M8 x 1.25	2.5

Tighten the bolt fixing the mounting bracket for the first section of the exhaust pipe to torque. - 1072C44 exhaust manifold heat shield on bulkhead - r+r - 1048A10 air cleaner filtering element - replace