2752811 - 4420A40 l/h or r/h rear suspension coil spring (one) - r+r

Removing ( Refitting ) Place the car on a ramp. - 4450B13  rear wheels(2) r r1. Fit the tool for supporting the rear axle on a hydraulic jack

	Name	Country
1	Mount	1.870.602.000

2. Position the hydraulic jack with appropriate tool in the centre of the rigid rear axle and fix it using the two knobs.Partly compress the rear suspension. 1. Unscrew the upper bolt securing the damper to the body.2. Remove the rear coil spring. Refitting ( Removing ) Check the condition of the coil spring.

Before refitting the rear coil spring, check that there are no cracks or distortions which would adversely affect its operation.

The rear coil springs are divided into two categories, identified by a stripe of blue paint on the centre coil. The springs fitted on the vehicle must belong to the same category.

Fit the rear coil spring, positioning it correctly in the appropriate housing on the rear axle.Screw in the upper bolt securing the shock absorber to the bodyshell without tightening it.Remove the hydraulic jack complete with support tool.

	Name	Country
-	Mount	1.870.602.000

 - 4450B13  rear wheels(2) r rRemove the vehicle from the ramp.Place the vehicle in the theoretical load conditions in order to torque tighten the bolts tightened previously.Take the car to a platform bridge so that the wheels can rest on the ground.Place the vehicle in standard 'A' conditions, i.e. with the spare wheel, tool kit, all fluids and a full tank of fuel. Check that the tyre pressures are correct.

	Measurement		Value
-	Front wheel pressure (bar)		2

	Measurement		Value
-	Rear wheel pressure (bar)		1.9

1. Check that the distance between the rear wing maximum curvature point and the wheel centre is 626 mm.

It should be remembered that this operation is vital to ensure the correct operation of the front suspension and prevent premature damage to the track control arm rubber bushes.

Tighten the bolts securing the shock absorbers to the body to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR DAMPER	M10 x 1.25	(Upper) 8