2753289 - 7050C05 Single sliding REAR SEAT with split folding squab - R.R .

Removing ( Refitting )  - 7040H80  parcel rackPlace the sliding rear seat in the forwards end of travel position.Fold the backrest over using the release devices.1. Remove the seat belt cover which is a press fit.2. Undo the bolt fixing the rear seat belt to the seat.Carry out the same operation on the opposite side. 1. Undo the rear bolts fixing the sliding guides to the floor.2. Undo the bolts fixing the centre attachment and sliding device. Move the single sliding rear seat backwards.1. Undo the front bolts fixing the seat to the floor.Remove the one-piece sliding rear seat passing it through one of the rear door housings.With the seat at the bench, release the sliding and attachment device from the housing on the seat frame. Refitting ( Removing ) Fit the one-piece sliding rear seat, passing it through one of the rear door housings and tighten the front and rear fixing bolts to the floor,.Working from the luggage compartment, fit the centre sliding and attachment device in the housing on the seat frame.Screw in the bolts fixing the centre sliding and attachment device without tightening them.Tighten the bolts fixing the centre attachment and sliding device to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	CENTRE REAR SEAT SUPPORT/GUIDE.	M10 x 1.25	(Front) 4.0

Tighten the rear bolts fixing the one-piece rear seat to the floor to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	Sliding one-piece REAR SEAT	M10 x 1.25	(Rear) 4.0

Tighten the front bolts fixing the one-piece seat to the floor to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	Sliding one-piece REAR SEAT	M10 x 1.25	(Front) 4.0

Tighten the bolts fixing the rear seat belts to the rear seat cushion to torque.Fit the covers which are a press fit.Raise the backrest and check that the attachment device is secured to the striker. - 7040H80  parcel rack