2753292 - 7050C21 COVER of sole cushion of sliding rear seat - R.R.

Removing ( Refitting )  - 7040H80  parcel rack - 7050C05  Single sliding REAR SEAT with split folding squab - R.R . - 7050C11  Single CUSHION of sliding rear seat - S.R.1. Release the retaining rods.2. Cut the fastening clips and place the seat belt grip housing trim forwards.3. Cut the fastening clips along the entire perimeter of the cushion cover.
1. Starting from the left and/or right side, break the fastening clips on the outer section.Turn the fabric over to gain access to the centre clips, then cut them.Turn the fabric over and cut the clips fastening the upholstery inner rod to the cover.Carry out the same procedure for the remaining half of the cover.2. Remove the complete cover from the upholstery.
Refitting ( Removing ) Check that the cover is intact and that there are no signs of wear or cuts.Fit the trim to the padding.Using the special pliers, attach the new clips in the centre section where the cover is joined to the upholstery.

NameCountry
-Pliers for metal points1.878.017.001
Continue attaching the clips in the outer areas. Fit the cover in the two housings for the seat belt handles.Attach the retaining rods.Attach the clips fastening the seat belt grip trim using special pliers.

NameCountry
-Pliers for metal points1.878.017.001
Attach the fastening clips along the entire perimeter of the cover using the special pliers.

NameCountry
-Pliers for metal points1.878.017.001
 - 7050C11  Single CUSHION of sliding rear seat - S.R. - 7050C05  Single sliding REAR SEAT with split folding squab - R.R . - 7040H80  parcel rack