7210E36 R.R. FRONT SIDE DOOR - Fiat - PANDA - eLearn

2753359 - 7210E36 R.R. FRONT SIDE DOOR

) Disconnect the battery negative terminal. - 7040L42 sill plate connection of one front door (1), lh or rh - r r . 1. Disconnect the electrical connections.

	Name	Connector
1	Front left door connection	D30A

	Name	Connector
1	Front left door connection	D30B

	Name	Connector
1	Front right door connection	D31A

	Name	Connector
1	Front right door connection	D31B

2. Remove the guard and release the electrical connections.

1. Undo the bolt fixing the door check strap.2. Undo the bolts (2a) and (2b) fixing the hinges.3. Release the cable duct and release the door wiring.

1. Lift up the door and remove it.

Refitting ( Removing

) Check that the front door is not damaged.If necessary touch up the paintwork.Position the front door on the hinges.Tighten the bolts fixing the hinges to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	SIDE DOORS	M6	1.5

Tighten the bolt fixing the door check strap to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT DOOR OPENING LIMITER	M8	(Bodyshell side) 2.5

Position the wiring inside the housing in the bodyshell and position the cable duct.Position the guard and connect the electrical connections.

	Name	Connector
-	Front left door connection	D30A

	Name	Connector
-	Front left door connection	D30B

	Name	Connector
-	Front right door connection	D31A

	Name	Connector
-	Front right door connection	D31B

- 7040L42 sill plate connection of one front door (1), lh or rh - r rCheck the alignment of the front door and, if necessary, carry out the following procedure: - 7005A14 front side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartmentConnect the battery negative terminal.