2752477 - 1040A70 submerged pump assembly complete with level guage control - r + r

Removing ( Refitting ) Disconnect the battery negative terminal.Move the load carrying compartment lining away from the work area.1. Undo the rear bolts fixing the rear seat cushion. 1. Undo the front bolts fixing the rear seat cushion.2. Remove the rear seat cushion. 1. Remove the submerged pump protective cover.2. Disconnect the rapid connector (2a) for the fuel supply pipe and disconnect the electrical connection (2b) for the submerged pump.

	Name	Connector
2b	Fuel pump and sender unit	N40

1. Position the tool (1a) and undo the ring nut (1b) fastening the submerged pump to the tank.

	Name	Country
1a	Key	1.870.736.000

2. Release the submerged pump complete with level gauge and remove it.Keep the gasket. Refitting ( Removing ) Place the submerged pump in position complete with level gauge.

Take care to ensure that the fitting reference on the submerged pump coincides with the one on the tank so that the pump is fitted in the correct position.

Fit the gasket.Tighten the ring nut fastening the submerged pump using the appropriate tool.

	Name	Country
-	Key	1.870.736.000

Connect the electrical connection to the pump.

	Name	Connector
-	Fuel pump and sender unit	N40

Connect the fuel pipe rapid connector to the pump.Fit the submerged pump protective cover.Place the rear seat cushion in position and tighten the fixing bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SEAT CUSHION.	M10 x 1.25	4

Refit the load carrying compartment lining.Connect the battery negative terminal.