2127E42 HYDRAULIC SELECTION GEARBOX SHIFT POSITION SENSOR - R R - Fiat - PANDA - eLearn

2752689 - 2127E42 hydraulic selection gearbox shift position sensor - r r

) Place the gear lever in neutral, N. - 5530B10 battery - r+r - 5530B56 BATTERY DRIP TRAY COVER - R.R. - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.Position a suitable container to collect the coolant.1. Open the retaining band (1a) and disconnect the pipe (1b), radiator side.Move the pipe away from the work area.

1. Disconnect the electrical connection for the braking system control unit.

	Name	Connector
1	Braking system control unit	M51

1. Move the front wiring section away from the work area.

1. Disconnect the electrical connection from the gear engagement position sensor.

	Name	Connector
1	Gear shift potentiometer	K69

2. Undo the bolts (2a) and remove the gear engagement position sensor (2b).3. Undo the bolts (3a) and remove the rear position signal relay (3b).

Refitting ( Removing

) 1. Fit the gear position signal relay, making sure to match the fork (1a) with the engagagement pin (1b) and secure it with its bolts.

Fit the gear engagement position sensor on the gear position signal relay, making sure to charge the potentiometer.

The potentiometer is charged by engaging the sensor on the rear position signal relay drive shaft and making it rotate by ninety degrees in relation to the final fitting position.

Connect the electrical connection to the gear engagement position sensor.

	Name	Connector
-	Gear shift potentiometer	K69

Refit the front wiring section.Connect the electrical connection for the braking system control unit.

	Name	Connector
-	Braking system control unit	M51

Connect the pipe from the radiator to the engine, radiator side, and secure it with the retaining band. - 0010T21 coolant check density and top up if necessary - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. - 5530B56 BATTERY DRIP TRAY COVER - R.R. - 5530B10 battery - r+rRemove the vehicle from the lift.Connect the Examiner diagnostic instrument and initialise the gear engagement/selection positions, checking that the engagement travel is correct.